|
Post by haitch on Feb 8, 2023 13:42:23 GMT 10
Is the seal a Ural item or can it be had at a bearing supplier? Do you have some numbers?
|
|
|
Post by Uralee on Feb 8, 2023 14:30:23 GMT 10
You will get one at local bearing shop. Sorry, I don’t have the number.
|
|
|
Post by haitch on Feb 8, 2023 17:06:31 GMT 10
Thanks Lee.
|
|
|
Post by haitch on Sept 24, 2023 16:16:42 GMT 10
Took the wheel out after the UAR. Just to check for anything untoward and to do some mods while I was in there. Wheel seems fine, spokes still ping and provides an opportunity to grease up splines etc. I did notice however, a different set of marks on the axle. I am assuming this is because I swapped out the spare for the original pusher after SA. The spare wheel bearing tolerances may be different and perhaps the cause. Anyway, I gave it a quick linishing and it will go back in. Photos for reference. The seals seem to be ok. As the original pusher is going back on, it will be interesting to see if I get the same marks as the first time.
|
|